PLATE 5T4195 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0510     Driver Group     1    Start By:
Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00577213
Align the timing mark on the idler gear with the timing mark on the crankshaft gear.
Remove four bolts (1) and plate (2) .
Remove idler gear (3) .
Illustration 2 g00577286
Remove the bearing from the idler gear with Tool (A) and a press.
Illustration 3 g00577251
Remove thrust washer (6). Remove five bolts (4) and shaft (5) .
Illustration 4 g00577252
Illustration 5 g00577274
The drilled passages (7) and (8) in the shaft must be free of obstructions.Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 6 g00577251
Illustration 7 g00537659
Tightening sequence for the stub shaft
Put shaft (5) in position on the cylinder block and install five bolts (4). Tighten bolts (4) to a torque of 55 10 N m (41 7 lb ft).Tighten the five bolts for the stub shaft in the following sequence. See illustration 7 for the numbering of the bolts. ... 1,3,4,5,2,1,2,3,4,5,1
Install thrust washer (6) with the oil groove side toward the idler gear.
Illustration 8 g00577286
Install the bearing in idler gear (3) with Tool (A) and a press. Install the bearing to a depth of 0.38 0.25 mm (0.015 0.010 inch).