PLATE 5V3847 - Caterpillar

Illustration 1 g00303463
Before you load the machine, chock the trailer wheels or the rail car wheels, as shown.
If necessary, remove the ballast from the machine. If liquid ballast (water) has been used, drain the water from the machine. Refer to Operation and Maintenance Manual, "Ballast - Remove/Install" for the procedure. Note: In freezing temperature, drain the water system and ballast tanks completely.
Drive the machine onto the trailer or onto the car.
Apply the parking brake.
Stop the engine.
Turn the engine start switch key to the OFF position. Remove the key.
Block the machine, and tie down the machine. Refer to the Operation and Maintenance Manual, "Lifting and Tying Down the Machine" for more information.
Turn the disconnect switch for the battery to the OFF position. Remove the key.
Lock the doors and the access covers, if equipped. Attach any vandalism protection. Install the cover on the console. Cover the operator seat.
To protect the cooling systems, mix a solution of antifreeze and water. The solution should provide protection to the lowest expected outside temperature. Drain the excess coolant into a suitable container.
Perform a daily inspection and measure the fluid levels in the various compartments. Refer to Operation and Maintenance Manual, "Every 10 Service Hours or Daily" for additional information.
Travel at a moderate speed. Observe all speed limitations when you are roading the machine. Consult your Caterpillar dealer for shipping instructions for your machine.