PLATE 6I1684 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9S-3263 Thread Lock Compound 1 Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01157416
Install spool (20) into valve body (15).
Illustration 2 g01157415
Install O-ring seals (17) and (18).
Install spool (19) into valve body (2).
Illustration 3 g01157413
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Apply Tooling (A) to bolts (16). Use bolts (16) to secure valve body (15) to valve body (2).
Install O-ring seal (13) on plug (12).
Install spring (14) and plug (12) into valve body (15).
Illustration 4 g01157412
Install shims (11) onto stop (4).
Illustration 5 g01157410
Install seals (10) into retainer (7).
Illustration 6 g01157409
Install plunger (9) into retainer (7).
Install O-ring seal (8) onto retainer (7).
Illustration 7 g01157406
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install spring (3), stop (4), spring (5), spring (6), and retainer (7) into valve body (2).
Illustration 8 g01157403
Install boot (1). End By:
Install the brake control valve. Refer to Disassembly and Assembly, "Brake Control Valve (Service) - Install".