PLATE-CLAMP 7C6672 - Caterpillar

Electric Power Generation:
All Engine: Industrial, Marine, and Generator Set that Use Flash Programming
AllDescription of Change: The Fall 2002 Software for Product Link Modules (PLM) was released on 20December 2002. This new software will make available the updates that are shown in Table 1. The Fall 2002 Software for Product Link Modules is can be obtained (in the form of a flash file) through Caterpillar Service Information System (SIS). Adaptable To: The new 232-6187 Product Link Software is now being used in production. 232-6187 Product Link Software is flashable (adaptable) to all PL-151 and all PL-210 Product Link that are in the field. The 232-6187 Product Link Software cannot be flashed onto PL-101 modules.Available Updates
Note: Flashing the 232-6187 Product Link Software will reset all configuration parameters to default. Therefore, the Product Link Module will have to be configured and registered again. Record the current PLM settings prior to flashing the new 232-6187 Product Link Software .Use Caterpillar ET's Winflash application to flash the file. Re-enter the previously recorded configuration settings and re-register the Product Link Module.
Table 1
Available Updates for the 232-6187 Product Link Software    
Update     Comments    
DC R-term input allowed     The R-terminal input that signifies that the Engine Running state can now be a DC signal (an alternating square wave had previously been required). This increases flexibility for retrofitting competitive machines where alternating current is not available. Certain Caterpillar machines also provide a DC signal for Engine Running.    
Primary Wireless Type     When using ET 2002B, the Primary Wireless Type descriptions will now be Satellite Basic for a PL-151 and Satellite Premium for a PL-201. Previous versions of ET will still show Opt. #4 See Service Manual and Orbcomm for PL-151 and PL-201 respectively.