PLATE 7G9702 - Caterpillar

7G9702 PLATE Caterpillar parts D10, D9L

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA7G9702
7G-9702
7G9702

Weight: 0.60 pounds 0 kg.

Buy PLATE 7G9702 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compatible equipment models: 7G9702:

TRACK-TYPE TRACTOR D10 D9L Caterpillar

Number on catalog scheme: 8

For full view, you need register

Information:

Start By:
Connect the steering frame lock. Refer to the Service Manual module Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".Upper Pin (C Pin)
Perform the following steps in order to remove the upper pin assembly.
Illustration 1 g01249372
Illustration 2 g01249389
Attach a suitable lifting device and Tooling (A) to lever assembly (1). Attach the hook of Tooling (A) to link assembly (2) with a suitable lifting device. The weight of link assembly (2) with a removed pin assembly (3) is approximately 220 kg (480 lb).
Remove bolts (4) and the washers.
Remove plate (5) .
Illustration 3 g00993014
Install Tooling (B) to pin assembly (3). The weight of Tooling (B) is approximately 115 kg (250 lb).
Illustration 4 g00993047
Attach a suitable lifting device to Tooling (B). Pull pin assembly (3) out of the bore approximately 175 mm (7.0 inch).
Illustration 5 g00993133
Install another suitable lifting device to Tooling (B) .
Pull pin assembly (3). Remove pin assembly (3) from Tooling (B). The weight of pin assembly (3) is approximately 60 kg (130 lb).Lower Pin (B Pin)
Perform the following steps in order to remove the lower pin assembly from the right side of the work tool.
Illustration 6 g01249395
Illustration 7 g00993382
Remove bolts (7) and washers.
Remove plate (8) .
Install Tooling (C) to pin assembly (6). The weight of Tooling (C) is approximately 95 kg (210 lb).
Pull pin assembly (6) out of the bore approximately 175 mm (7.0 inch).
Illustration 8 g00993384
Install another suitable lifting device to Tooling (C) .
Remove pin assembly (6). At this time, the shims will also be removed.Note: Mark the shims and the location of the shims for assembly.
Remove pin assembly (6) from Tooling (C). The weight of pin assembly (6) is approximately 60 kg (130 lb).
Perform Step 1 through Step 7 in order to remove the lower pin assembly from the other side of the work tool.
Lower link assembly (2) in order to clear the work tool at removal. When the upper pin assembly and the lower pin assemblies are removed, separate the steering frame lock. Start the engine and move the machine away from the work tool.
Illustration 9 g00993648
Turn the engine start switch to the OFF position. Raise link assembly (2). Use a cable and cable clamps in order to tie the link assembly to the lever and bearing assembly.
Remove Tooling (A) and the suitable lifting device.