PLATE-BLOCK 7N8021 - Caterpillar

The Electronic Module Control Panel II (EMCP II) is located above the distribution panel which is at the rear of the enclosure. The control panel consists of a main panel with indicators, meters and control switches.
Illustration 1 g00793163
Typical EMCP II (1) Generator Set Control (2) Alarm module (3) Custom alarm module (4) Optional speed potentiometer (SP) or optional governor switch (GS) (5) Panel lights (PL) (6) Control panel (operation) (7) Caterpillar Monitoring System (CMS) (8) Voltage adjust rheostat (9) Engine control switch (ESC) (10) Panel light switch (PLS) (11) Emergency stop push button (ESPB)Generator set control (GSC) (1) - The left side of the control panel contains the Generator Set Control (GSC). This is the main component of the system. The GSC displays generator output, fault conditions, and key engine parameters. Alarm Module (2) - The alarm module provides a warning of engine conditions. This warning is given before conditions become so severe that the engine shuts down or conditions become severe enough to prevent the engine from starting.Custom Alarm Module (3) - This alarm module is an optional feature. Speed Potentiometer (4) - The engine is equipped with an electronic governor. A speed potentiometer is mounted in this location.Panel Lights (5) - The panel lights are controlled by the Panel Light Switch (10) .Control panel (6) - The control panel controls the operation of the generator set.Caterpillar Monitoring System (CMS) (7) - The main display module continuously monitors all generator set systems.Voltage Adjust Rheostat (8) - The voltage adjust rheostat is used to adjust the generator output voltage to the desired level.Engine Control Switch (9) - The engine control switch determines the status of the control panel. In the AUTO position (3 o'clock), the engine will start automatically whenever a remote start/stop initiate contact is closed. The engine will stop after the initiate contact opens and after an adjustable cooldown period has elapsed. A cooldown period can be programmed. This cooldown period (0 to 30 minutes) will allow the engine to dissipate heat before the engine shuts down.Panel Light Switch (10) - The panel light switch operates the panel lights (5) .Emergency Stop Push Button (11) - The emergency stop push button is used to shut down the engine during an emergency situation. The engine is shut down by shutting off the fuel supply. Do not use the emergency stop push button to shut down the engine under normal circumstances.Generator Set Control (GSC)
Illustration 2 g00591650
(1) Indicators (2) Upper display (3) Lower display (4) Keypad The left side of the control panel contains the Generator Set Control (GSC). This is the main component of the system. The GSC also displays the following information:
generator output
generator set functions
fault conditions
key engine parametersThe GSC accepts information from the following sources: operator, magnetic pickup, oil pressure sensor, water temperature sensor and optional remote sources This information is used to determine the on/off state of the engine's air, fuel, and starter. Under basic operating conditions, the GSC receives a signal in order to run the generator