PLATE 7S5468 - Caterpillar

Personal injury or death can result from bucket falling.Block the bucket before changing bucket cutting edges.
Illustration 1 g00764365
(1) Bolts for Cutting Edge
(2) Cutting Edge Check the cutting edges and the end bits for wear and for damage. Use the following procedure to service the cutting edges and the end bits:
Raise the bucket and place blocking under the bucket.
Lower the bucket onto the blocking. Stop the engine.
Remove bolts (1), cutting edge (2) and the end bits.
Clean all contact surfaces.
If the opposite side of the cutting edge is not worn, use the opposite side of the cutting edge. The end bits are not reversible. If both sides are worn, install a new cutting edge.
Install bolts (1). Tighten the bolts to the specified torque. Reference: Refer to Specifications, SENR3130, "Ground Engaging Tool (G.E.T.) Fasteners".
Start the engine. Raise the bucket and remove the blocking. Lower the bucket to the ground.
After a few hours of operation, check the bolts for proper torque. Bucket Wear Plates
Personal injury or death can result from the bucket falling.Block the bucket before changing bucket wear plates.
Illustration 2 g00879740Inspect the wear plates. Replace the wear plates before damage to the bottom of the bucket occurs. Consult your Caterpillar dealer for replacement of wear plates.