PLATE 8D8806 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that identified below.Problem
Some sites with C175 Machine Engines have experienced water and dirt entry into the 70-pin ECM connector. If moisture is trapped in the connector, it can cause pin and socket corrosion. Pin-70 is on the bottom of the connector and contains the keyswitch power signal for the engine. If this pin corrodes or loses connection, the engine may shut off.Solution
Care should be taken when pressure washing or cleaning this area of the engine to make sure that water does not enter the connector.Note: Evaluate the condition of the pins and sockets if the connectors are removed for any reason.
Illustration 1 g06076775
(1) 120–pin ECM connector
(2) 70–pin ECM connector
Disconnect ECM connector (1) and (2) from the ECM.
Illustration 2 g06076812
(3) Pin-70 (Keyswitch Power)
Find the location of Pin-70 (3) for the keyswitch power.
Illustration 3 g06076830
(4) Example of Pin-70 corroded
Check Pin-70 for corrosion. If corrosion is found, then repair as necessary. Report any occurrences of pin corrosion or ECM power loss through the Dealer Solutions Network (DSN).