PLATE 8J6346 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0510 Driver Group 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01218982
Illustration 2 g01219045
Illustration 3 g01219048
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Use Tooling (A) to install the bearings in body assembly (1) until the bearings are even with the outside surface of body assembly (1). Install the bearings so the junctions in the bearings are Angle (X). Angle (X) is 30 15 degrees from the center line of the bearing bores and toward the outlet passage in the engine oil pump.
Install plunger (8), plunger ring (9), and spring (10).
Install retainer (11) and bolts (12).
Install shaft assemblies (2).
Use Tooling (A) to install the bearings in cover assembly (3) until the bearings are even with the outside surface of cover assembly (3). Install the bearings so the junctions in the bearings are Angle (Y). Angle (Y) is 30 15 degrees from the center line of the bearing bores, and toward the outlet passage. The outlet passage has a cavity between the bearing bores.
Install cover assembly (3) on body assembly (1). Install bolts (4).
Install the key into the pump shaft. Install drive gear (5). Install washer (6) and bolt (7). Tighten bolt (7) to a torque of 55 10 N m (41 7 lb ft). End By:
Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".