PLATE 8N9103 - Caterpillar

Caterpillar: Confidential Yellow
The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.
This Program can be administered either before or after a failure. In either case the decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS4216" as the Part Number and "7755" as the Group Number. If administered before failure, use "56" as the Warranty Claim Description Code and use "T" as the SIMS Description Code. If administered after failure, use "96" as the Warranty Claim Description Code and use "Z" as the SIMS Description Code.
This Revised Service Letter replaces the October 18, 1997 Service Letter. Changes have been made to the Parts Needed.
Termination Date
October 31, 1998Problem
The turbine housing on some C-12 Truck Engines needs to be replaced to reduce vibration in the wastegate.
Affected Product
Model & Identification Number
C-12 (9NS372-639)
Parts Needed
4 - 3E8017 Locknut1 - 1S4295 Gasket1 - 1S7057 Gasket1 - 7W2398 Gasket1 - 1142687 Seal1 - 1513083 Turbine Housing AssemblyAction Required
1. Remove turbocharger.2. Remove and replace existing turbine housing with the new turbine housing.3. Install turbocharger. Tighten the four locknuts to a torque of 70 N m (51 lb ft).4. Tighten the V-band clamp assembly as indicated in Illustration 1.
(1) Clamp (Turbin Housing)Install clamp (1) as follows:
Tighten clamp to a torque of 18 N m (160 lb in).Loosen clamp to a torque of 6 N m (53 lb in).Tighten again to a torque of 14 1 N m (120 9 lb in).Service Claim Allowances
Parts Disposition
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.