PLATE ASSEM. 8S7250 - Caterpillar

Remove nut (4), cable assembly (6), and cable assembly (5) from electric starting motor (3) .
Illustration 3 g01366782
Remove nut (9) and ground strap (11) from electric starting motor (3) .
Loosen screw (7) and remove cable harness (8) from electric starting motor (3) .
Remove bolt (10), cable assembly (14), cable assembly (13), and ground strap (12) .
Illustration 4 g01366783
Remove the nuts, harness assembly (18), harness assembly (17), and cable assembly (16) from alternator (15) .
Illustration 5 g01366858
Disconnect harness assembly (21). Remove cable strap (20). Lay cable assembly (16) and harness assembly (19) out of the way.
Illustration 6 g01366859
Remove cable straps (22), (23), and (24). Lay cable assembly (16) and harness assembly (19) out of the way.
Illustration 7 g01366860
Remove bolt (25) and the clamp. Lay the cable assemblies and harness assemblies out of the way.
Illustration 8 g01366785
Remove serpentine belt (27) from engine (26) .
Disconnect harness assembly (28) and (30) from air conditioner compressor (29) .
Illustration 9 g01366786
Remove bolts (31) and lay air conditioner compressor (29) to the side of the machine.
Illustration 10 g01366787
Loosen the clamps and remove hoses (32) and (34) .
Disconnect hose assembly (33) from the fuel filter.
Illustration 11 g01366788
Remove bolt (35), bolt (36), and the clamps. Lay hoses (32) and (34) out of the way.
Remove bolts (38) and the clamp. Disconnect hose assembly (37). Lay hose assembly (37) out of the way.
Remove bolts (43) and the clamp. Loosen clamp (40) and remove hose (42) .
Disconnect hose assembly (39) .
Loosen clamp (41) and remove hose (44) .
Illustration 12 g01367000
Remove cable straps (47) and (50) .
Loosen clamp (46) and remove hose (48) .
Remove bolts (49) and panel (45) .
Illustration 13 g01367001
Remove bolt (51) and the clamp. Move hose assemblies (32) and (34) out of the way.
Place a suitable block under the back of the pump group. Use a suitable strap, blocks, and bar in order to suspend the front of the pump group.
Remove bolts (52) in order to separate the engine from the pump group.
Illustration 14 g01367002
Attach Tooling (A) and a suitable lifting device to engine (26), as shown.
Remove bolts (53) and (54) .
Be sure that the harness assemblies, hose assemblies, and hoses are out of the way.
Use Tooling (A) and the suitable lifting device in order to move engine (26) toward the rear of the machine until the splines on the propel pump are removed from the flange of the pump drive. Remove engine (26) from the machine. The weight of engine (26) is approximately 454 kg (1000 lb).