PLATE (FOR OUTSIDE JAPAN) 8T6783 - Caterpillar

Travel Speed Control Switch
Illustration 12 g00577641
This safety message is positioned in the cab.
g00577852
Put travel speed control switch in LOW position before descending a slope or loading or unloading on trailer. If travel speed control switch is in HIGH position during these operations, sudden changes in machine speed can occur with an adverse effect on machine control, resulting in personal injury.
Electrical Shock Hazard (If Equipped)
Illustration 13 g00111744
This safety message is located on the engine. This is a typical example of the location of the safety message.
g00039226
Electrical shock hazard. The electronic unit injector system uses 90-120 volts.
The Electronic Control Module (ECM) sends a high voltage signal to the injector solenoid. To help prevent personal injury, disconnect the electronic unit injector enable circuit connector. Do not come in contact with the electronic unit injector terminals while the engine is running.Pressurized System
Illustration 14 g00577642
This safety message is positioned on the access cover for the radiator.
g00100763
PRESSURIZED SYSTEM: HOT COOLANT CAN CAUSE SERIOUS BURN. TO OPEN CAP, STOP ENGINE, WAIT UNTIL RADIATOR IS COOL. THEN LOOSEN CAP SLOWLY TO RELIEVE THE PRESSURE.
Electrical Shock Hazard
Illustration 15 g00709499
This safety message is located in two places on the generator for the magnet. The generator for the magnet is located inside the cab riser.
g00709188
Before servicing, turn generator disconnect switch to the OFF position. Failure to do so could result in serious injury or death.
Product Link (If Equipped)
Illustration 16 g01026732
This safety message is located in the cab.
g01013264
This machine is equipped with a Caterpillar Product Link radio communication device which must be deactivated within 6.0 m (20 ft) of a blast zone. Failure to do so could result in serious injury or death.