PLATE ASSEM. (L.H.) 8V6312 - Caterpillar

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes.
Illustration 1 g02146704
Illustration 2 g02146705
Start the machine and lower the tow arm.
Shut off the machine. Turn the disconnect switch to the OFF position.
Disconnect hose assemblies (3) from hydraulic cylinder (2).
Remove the cotter pin and pin assembly (4).
Remove the cotter pin, pin assembly (1), and hydraulic cylinder (2). Installation Procedure
Illustration 3 g02146704
Illustration 4 g02146705
Install hydraulic cylinder (2), pin assembly (1), and the cotter pin.
Install pin (4) and the cotter pin.
Connect hose assemblies (3) to hydraulic cylinder (2).