PLATE-CLUTCH 9P3242 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2 Start By:
Remove the fuel control valve. Refer to Disassembly and Assembly, "Fuel Control Valve - Remove and Install".
Remove the throttle control valve. Refer to Disassembly and Assembly, "Throttle Control Valve - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the two-stage cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g01684299
Attach Tooling (A) and a suitable lifting device to aftercooler (1). The weight of aftercooler (1) is approximately 323 kg (711 lb).
Support the air cleaner lines and remove U-bolts (5) from both sides. Remove bolts (3) and remove bracket (2).
Remove bolts (8), the retainers, the O-ring seals, and tube assembly (9).
Remove bolts (10), the retainers, the O-ring seals, and tube assembly (11).
Remove bolts (6), the washers, and tubes (7) from both sides of aftercooler (1).
Disconnect tube assembly (13). Remove bolts (4).
Remove bolts (12 ) from aftercooler (1) to the support assembly.