PLATE 9P9789 - Caterpillar

Illustration 1 g01197340
Schematic for the Tilt Lever Position SensorThis diagnostic code is recorded when the ECM determines that the signal from the tilt lever position sensor is out of location. The tilt lever sensor is a 500 Hz PWM sensor.The possible causes for this diagnostic code are listed:
The tilt lever position sensor needs recalibrated.System Response:The machine response is listed:
The diagnostic code is active for at least three seconds, then the 353-13 diagnostic code will become active. The 353-00 diagnostic code will become inactive.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected. Note: Ensure that the diagnostic code is active.Test Step 1. RECALIBRATE THE LEVER POSITION SENSOR.Recalibrate the lever position sensor. Refer to Testing and Adjusting, "Position Sensor for the Electrohydraulic Control Levers or Joystick Control (Electronic Technician) - Calibrate".Expected Result:A successful calibration causes this diagnostic code to become inactive. Results:
YES - The calibration causes this diagnostic code to become inactive. Resume normal machine operation. Stop.
NO - The calibration has not caused the diagnostic code to become inactive.Repair: Replace the lever/joystick. Stop.