PLATE-PORT 9T1689 - Caterpillar

The CAN device firmware files allow you to upgrade the GPS receivers to the current firmware version. Use the display in order to complete the upgrade. The controls firmware is available on the display or SIS Web.The AccuGrade system contains two GPS receivers.Complete the following steps in order to upgrade the firmware of each device:
Use a computer to copy the upgrade files to the root folder of a data card. There are two types of firmware upgrade files:GPS Receiver loader files - MSMONnnn.s (where nnn is the version number). This loader upgrade file is available on SIS Web.Application upgrade files - AAAAA nnn.S, where AAAAA is the unit type, and nnn is the version number. This upgrade file is available on the AccuGrade system software CD in the "CAN Device Firmware" folder that is named "MS990100.S".
Place the data card, with the firmware on the root directory, into the display.Note: For the latest revision of firmware, use SIS Web.
Press the "OK" key while pressing the "Power" key in order to start up the display in the "Service" mode.
From the "Setup Menu" dialog, press the "Installation" soft key in order to list the items that are under the "Setup Menu – Installation" dialog.
Press the up arrow or press the down arrow until "Upgrade Firmware" is highlighted.
Illustration 1 g01473152
Note: The display also stores the minimum version of software for the components.
Press the "OK" key. If at least one device was detected on the CAN bus, a dialog similar to Illustration 2 will appear.This dialog lists all the correctly named .s files in the root folder of the data card, that are applicable for the machine type selected. The version of each file is also shown.
Illustration 2 g01473255
Press the up arrow or the down arrow in order to highlight either the "MS990" file or the "MS990 Loader" file.
Press the "OK" key. A dialog that is similar to Illustration 3 will appear.The dialog displays the current application and loader version of the two GPS receivers. It also prompts you to select which receiver to upgrade.
Illustration 3 g01473257
Disconnect the radio.
Press the down arrow or the up arrow in order to select "MS990 - Left" or "MS990 - Right".Note: You must upgrade both the left GPS Receiver and the right GPS Receiver to the same application and loader firmware versions.
Press the "OK" key. A dialog that is similar to Illustration 4 will appear.The firmware upgrade begins. A progress bar appears.Note: Do not remove the card or turn off the display during the firmware upgrade.
Illustration 4 g01473260