PLATE 9V8418 - Caterpillar

(1) Wet discs with transmission oil on assembly. Thickness of one new 8D9718 Disc ... 1.4 - 1.65 mm (0.055 - 0.065 in.)Thickness of one new 6Y7955 Friction Disc ... 2.79 - 2.95 mm (0.110 - 0.116 in.)(2) Install plug with 5P3413 sealant.(3) Torque for valve cartridge ... 47 - 54 N m (35 - 40 lb.ft)(4) Torque for bolts ... 47 - 61 N m (35 - 45 lb.ft)(5) Torque for bolts ... 120 - 150 N m (88 - 111 lb.ft)(6) Install shims to provide bearing end float of ... 0.05 - 0.16mm (0.002 - 0.006in.)(7) Install studs so this dimension is ... 100 - 102 mm (3.94 - 4.02 in)(8) Position plate with hole at the bottom as shown.(9) Smear the spring locating diameter and face with molybdenum based high pressure grease on assembly. Springs must be installed as shown.(10) Use 6V6640 Sealant on these joints.Bearing Adjustment Procedure
The idler gear bearings and differential bearings are adjusted with shims located between the casing and bearing housing.The adjustment procedure is the same as that for 7U8775 Output Transfer Drive. Refer to the topic "Output Transfer Drive (7U8775) - Bearing Adjustment".Brake Check
The brake check is the same as that for 7U8775 Output Transfer Drive. Refer to the topic "Output Transfer Drive (7U8775) - Brake Check". 7U6711 Output Transfer Drive is used on D20D and D250D models.