PLATFORM AS 3315208 - Caterpillar

3315208 PLATFORM AS Caterpillar parts 785C

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3315208
331-5208
3315208

Weight: 770 pounds 349 kg.

Buy PLATFORM AS 3315208 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Osborn Side-Action Internal Tube Brush, Brush Dia: 1", Bristle Dia.: 0.005", Brush Length: 5/8" (Pack of 10)

$236.78

22 Dec 2021

US: Omskva

Osborn Side-Action Internal Tube Brush, Brush Dia: 1", Bristle Dia.: 0.005", Brush Length: 5/8" (Pack of 10)
Generic bristle diameter: 0.005 in || bristle material: Stainless Steel || brush diameter: 1 in || overall length: 2-1/4 in || brush length: 5/8 in

Number on catalog scheme: 3

Caterpillar 3315208 Parts scheme PLATFORM AS

For full view, you need register

Compatible equipment models: 3315208:

TRUCK 785C Caterpillar

Information:

Installation Procedure
Identify a location for installation of the bottle. Ensure that the location for installation is protected. Ensure that the location of the bottle is lower than the nozzle.Follow the steps that are listed below in order to install the bottle.
Locate the nozzle in a horizontal position less than 3.0m (10 ft) away from the bottle.
Locate the bottle no lower than 1.5 m (5 ft) from the nozzle.
Inspect the location for the installation and ensure that welding in the location will not damage any of the nearby components.
Illustration 3 g01341843
Typical Location of Installation for the Bottle
Weld the bosses onto the frame in order to mount the bottle.
Install the bottle for the cleaning system.
Mount the nozzle.The following requirements need to be followed for the installation of the nozzle.
Illustration 4 g01341929
For optimal performance install the nozzle within 25 mm (1 inch) of the camera lens.Note: When installing the nozzle ensure that the nozzle is not viewable in the camera image.
The nozzle needs to be angled at 45 degrees from the surface of the lens.
Illustration 5 g01338194
Nozzle
Mount the spray nozzle so that the projection of the spray cuts at the base of the glass.
Install the wiring harness. Route the wiring harness with the existing wiring harnesses.
Illustration 6 g01341873
Typical Installation of the Wiring Harness
Install the power wire to the pump. Install the ground wire to the pump. Refer to Illustration 9 for a system schematic.
Locate an suitable ground and Install the other end of the ground wire to the frame.
Locate a location for installation in the cab of the machine for the washer switch.
Illustration 7 g01341911
Typical Installation of the Washer Switch
Connect the cleaning system to an appropriately fused 24 volt power source.
Illustration 8 g01338195
Check Valve
Route the fluid line from the pump to the nozzle. Cut the fluid line and install the check valve no more than 304 mm (1 ft) away from the tank. Ensure that the arrow on the check valve is pointed away from the pump.Note: You must prime the pump before installing the check valve. In order to prime the pump allow the water to flow out of the line in order to purge the air out of the line.
Check the operation of the system.Wiring Schematic
Illustration 9 g01341969
System Connections