AVSPARE.COM
parts catalog

PLATFORM GP-ACCESS 3727706 - Caterpillar



3727706 PLATFORM GP-ACCESS Caterpillar parts PLATFORM
Rating:
31
Alternative (cross code) number:
CA3727706
372-7706
3727706
Caterpillar 3727706 PLATFORM GP-ACCESS

Buy PLATFORM GP-ACCESS 3727706 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 5
 
  For full view, you need register

Information:

Removal Procedure
Start By:
Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Remove the oil supply tube assembly. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
The connecting rod caps and the connecting rods are matched to each cylinder. Note the markings on each connecting rod cap and on each connecting rod for later installation.Note: The left side and the right side of the engine are determined from the flywheel end.
Illustration 1 g01047932
Rotate the crankshaft until the piston is at the bottom center. Remove connecting rod nuts (5) from connecting rod bolts (2). Remove connecting rod cap (4) from connecting rod (1) .
Remove the lower half of connecting rod bearing (3) from connecting rod cap (4) .
Remove the upper half of connecting rod bearing (3) from connecting rod (1). Push the connecting rod away from the crankshaft, if necessary. Note: Use tape or rubber tubing on connecting rod bolts to protect the crankshaft journals. The sharp edges of the connecting rod bolts could damage the crankshaft journals.Note: Ensure that identification mark (X) on the connecting rod matches the identification mark on the connecting rod cap. The identification marks must be on the right side for installation purposes.
Repeat Steps 1 through 3 for the remaining connecting rod bearings.

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
TH514C, TH417C, TH407C, TH414C, TH406C, TH337C, TH336C, Telehandler Transmission DJB00001-00483 (MACHINE)
TH414C Telehandler KEK00373-UP (MACHINE)
TH417C Telehandler RRJ00246-UP (MACHINE)
TH514C Telehandler KKW00177-UP (MACHINE)


Parts platform Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.