PLIERS 1P1853 - Caterpillar

1P1853 PLIERS Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1P1853
1P-1853
1P1853

Weight: 0.010 pounds 0 kg.

Buy PLIERS 1P1853 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

WVE by NTK 1P1853 Back Up Light Switch Connector, 1 Pack

$45.86

26 Sep 2024
0.11[0.05] pounds
US: Wheels Depot

WVE by NTK 1P1853 Back Up Light Switch Connector, 1 Pack
WVE by NTK Pigtails provide electrical connection to various sensors and actuators || When not replaced, vehicle may experience intermittent or complete loss of electrical connection and/or oxidation of terminals || Designed to meet or exceed OE specifications in form, fit and function || Global coverage for import and/or domestic applications

$61.34

10 Jun 2024
0.11[0.05] pounds
US: Wheels Depot

$57.19

19 May 2024
0.11[0.05] pounds
US: Wheels Depot

This part in 1 request: Show. This information for suppliers only!

#1281912 1P1853

2024-02-03

For full view, you need register

Information:

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01254472
Typical example
Follow Step 1.a through Step 1.c in order to assemble the engine oil cooler.
Ensure that cooler matrix (3) is clean and free from damage. Ensure that housing (5) is clean and free from damage. Replace any damaged components.
Position new gasket (4) onto housing (5). Install cooler matrix (3).
Install bolts (6) finger tight.
Clean the face of the cylinder block.
Install bolts (7) to the engine oil cooler. Note: The bolts are different lengths. Ensure that the different bolts are installed in the correct location. Ensure that any brackets that are secured by the bolts are installed in the correct location.
Install a new gasket (2) to the assembly of oil cooler (1). Push bolts (7) through the holes in the gasket. Note: The holes in the gasket have serrations that hold the bolts captive.
Illustration 2 g01254473
Tightening sequence for the engine oil cooler
Install the assembly of oil cooler (1) to the cylinder block. Tighten bolts (7) to a torque of 22 N m (16 lb ft). Tighten the bolts in the sequence that is shown in Illustration 2. Tighten bolts (6) to a torque of 22 N m (16 lb ft). Refer to Illustration 1.
Place the engine wiring harness in the correct position. If necessary, install a new cable strap.
If necessary, Install the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install".
Fill the cooling system to the correct level. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
Fill the engine oil pan to the correct level. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct procedure. End By:
Install the bracket for the Electronic Control Module. Refer to Disassembly and Assembly, "ECM Bracket - Remove and Install".