PLUG 00103879 - Caterpillar

Illustration 4 g01359737
Remove bolts (7) and screws (8). Remove duct (9).
Illustration 5 g01359741
Remove screws (10) in order to remove case (11).
Illustration 6 g01359747
Remove screws (12) and position resistor assembly (13) and harness assembly (14) out of the way.
Illustration 7 g01359760
Disconnect harness assembly (14).
Illustration 8 g01359771
Remove blower motor (15).
Illustration 9 g01359786
Inspect gasket (16) for wear or damage. Replace gasket (16), if necessary. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 10 g01359786
Install a new gasket (16), if necessary.
Illustration 11 g01359771
Install blower motor (15).
Illustration 12 g01359760
Connect harness assembly (14).
Illustration 13 g01359747
Position harness assembly (14) and resistor assembly (13). Install screws (12).
Illustration 14 g01359741
Install case (11). Install screws (10).
Illustration 15 g01359737
Install duct (9). Install screws (8) and bolts (7). Note: Ensure that the foam insulation is positioned correctly.
Illustration 16 g01359732
Install support assembly (6). Install bolts (5).
Illustration 17 g01359671
Install plate (4). Install screws (3).
Illustration 18 g01359711
Position fuse panel (2). Install screws (1). End By:
Install the seat. Refer to Disassembly and Assembly, "seat - Remove and Install".