PLUG 0676803 - Caterpillar

Illustration 1 g02551165
Schematic of the Lift Linkage Position Sensor
This diagnostic code is associated with the Lift Linkage Position Sensor. The FMI 08 means that the ECM has determined that the signal frequency or the signal pulse width is not within the expected range. The output frequency of the position sensor is approximately 500 hertz. The duty cycle of the signal changes as the position sensor moves.Lift Linkage Full Range - 2 percent to 98 percent duty cycle The possible causes of this diagnostic code are listed below:
The wrong sensor has been installed.
The sensor has failed.
Intermittent connections or poor connections.
Mechanical devices are loose.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0350 FMI 08 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The kickouts will not function properly. The implements will function slowly. The snubbing of the lift cylinder will not function. The calibration procedure for the implement valves may not function properly. The “feather catch” feature for the lift linkage will not function properly.Note: The “feather catch” feature allows the lift linkage to slow down gradually when the control lever is moved abruptly from the lower position to the center position.Test Step 1. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the voltage supply wire (contact A).
Turn the key start switch and the disconnect switch to the ON position.
Measure the voltage from contact A to frame ground. Expected Result:The voltage is 24 DCV.Results:
OK - The voltage is 24 DCV. Proceed to Test Step 2.
NOT OK - The voltage is not 24 DCV. The circuit is open. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE SIGNAL CIRCUIT OF THE SENSOR.
Turn the key start switch and the disconnect switch to the OFF position.
At the back of the harness connector for the sensor, remove the 7X-1710 Multimeter Probe from contact A and insert the probe along the signal wire (contact C).
At the back of the harness connector for the sensor, insert the 7X-1710 Multimeter Probe along the ground wire (contact B).
Turn the disconnect switch and the key start switch to the ON position.
Monitor the signal of the sensor with the 146-4080 Digital Multimeter.
Without disconnecting the sensor or the hardware that is associated with the sensor from the machine, take the sensor through the full operating range of the sensor. Note: On some machines, it may be necessary to start the engine in order to take the sensor through the full operating range of the sensor.Expected Result:The sensor signal responds in the manner that is described at the beginning of this procedure.Results:
OK - The sensor signal responds correctly. The sensor