PLUG-RUBBER 1868239 - Caterpillar

Connection Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 260-9412 Chain As 1
B 5P-6214 Track Block Assembly 1
C 350-7768 Electric Hydraulic Pump Gp (115V) 1
350-7769 Electric Hydraulic Pump Gp (230V) 1
8T-0820 Hydraulic Pressure Gauge 1
3B-7722 Pipe Bushing 2
1P-2376 Quick Connect Coupler 2
1P-2377 Plug As 2
6D-7726 Hose As 2
5P-2379 Track Press Tool Gp 1
8S-7172 Double Acting Cylinder 1
8S-9903 Track Press Rollover Gp 1
Illustration 1 g01167157
Illustration 2 g01167155
Use Tooling (A) to raise the track into position.
Install pin (4) and cotter pin (3).Note: If you cannot install pin (4) with a suitable hammer, use Tooling (C) to install pin (4).
Illustration 3 g01167154
Install track shoe (2) and bolts (1). Tighten bolts (1) to a torque of 400 70 N m (295 52 lb ft). Tighten bolts (1) by an additional 120 degrees.
Illustration 4 g01174955
Remove Tooling (B) from both ends of the track assembly.
Adjust the track tension. Refer to Operation and Maintenance Manual, "Track Adjust" for the correct procedure.