PLUG 1R8869 - Caterpillar

Illustration 9 g00882324
Install swashplate (17) onto rotating group (14) .Note: Barrel assembly (19) is rotating group (14) upon the installation of the pistons.Note: Place identifying marks on swashplate (17) in order to locate two holes on the top of the swashplate.
Illustration 10 g00882976
Install shaft (2) into rotating group (14) .Note: Splines in shaft (2) must engage splines in rotating group (14) .
Illustration 11 g00882984
Illustration 12 g00882988
Align swashplate (17) with housing (3) .Note: The holes on the top of swashplate (17) must engage the dowels in housing (3) .
Illustration 13 g00882991
Install rotating group (14) into housing (3) .
Illustration 14 g00882992
Raise the temperature of sleeve (15) . Install sleeve (15) onto shaft (2) .
Illustration 15 g00882156
Install shim (13) onto shaft (2) .
Illustration 16 g00882123
Install bearing cone (12) onto shaft (2) .Note: Bearing cone (12) is a slip fit.
Illustration 17 g00882112
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install valve assembly (9) , sleeve (10) , and plug (11) into cover (5) .
Illustration 18 g00881963
Use Tooling (A) to install bearing cup (8) into cover (5) .
Illustration 19 g00883138
Illustration 20 g00881953
Install port plate (6) onto cover (5) .Note: Take note of the slot in the reverse side of port plate (6) . The slot will receive the dowel in cover (5) .
Install O-ring seal (7) on cover (5) .
Illustration 21 g00881945
Install cover (5) onto housing (3) .
Secure cover (5) with bolts (4) .
Illustration 22 g00881939
Install key (1) into shaft (2) .End By: Install the piston motor. Refer to Disassembly and Assembly, "Piston Motor (Hydraulic Fan) - Install ".