PLUG AS 2416168 - Caterpillar

Install the circuit breaker (25) for the switch for the mirror to the empty top hole in the circuit breaker panel with two screws (27) .
Install the circuit breaker (26) for the left hand mirror to the empty middle hole in the circuit breaker panel with two screws (27) .
Install the circuit breaker (26) for the right hand switch to the empty bottom hole in the circuit breaker panel with two screws (27) .
Install terminals "C-T6" and "C-T5" of harness (28) to circuit breaker (25) for the switch for the mirror. See Illustration 14.
Install terminals "C-T2" and "C-T1" of harness (28) to the circuit breaker (26) for the left hand mirror. See Illustration 14.
Install terminals "C-T4" and "C-T3" of harness (28) to the circuit breaker (26) for the right hand mirror. See Illustration 14.
Illustration 17 g01405318
Type 1Location for serial number prefixes "4GZ"
Type 1. Install relay (29) for the heated mirror to the cab with bolt (30) and hard washer (31) .
Type 1. Install timing relay (32) for the heated mirror to the cab with bolt (30) and hard washer (31) .
Illustration 18 g01413396
Type 2Location for serial number prefixes "1HL", "4AR", and "ATY"Alternate location for serial number prefixes "4GZ" (A) 138.9 mm (5.47 inch) (B) 64 mm (2.5 inch) (C) 13.8 mm (0.54 inch) diameter, 4 holes (W3) 3 mm (0.1 inch) Fillet weld all around, four weldnuts
Type 2. Use plate (34) to locate the four positions for four weldnuts (33). Drill four holes (C) .
Type 2. Locate four weldnuts (33) to the drilled holes (C) in the cab floor. Install the weldnuts with weld (W3) .
Illustration 19 g01413274
Type 2Location for serial number prefixes "1HL", "4AR", and "ATY"Alternate location for serial number prefixes "4GZ"
Type 2. Position plate (34) to weld nuts (33). Use four bolts (35) and four washers (36) in order to secure plate (34) .
Type 2. Install relay (25) or the heated mirror to the cab with bolt (30) and hard washer (31) .
Type 2. Install timing relay (32) for the heated mirror to the cab with bolt (30) and hard washer (31) .
Install connector "C-C3" of harness (28) to relay (29) or the heated mirror. See Illustration 14.
Install connector "C-C2" of harness (28) to timing relay (32) for the heated mirror. See Illustration 14.
Illustration 20 g01405319
Front view of connector
For machines with a serial number prefix of (S/N: ATY), remove the plug from socket "13" of 25-pin connector (X). Connect the white wire "C-T9" of wiring harness (28) to socket "13" of the 25-pin connector on cab harness (W). See Illustration 14 and Illustration 15.
For all other models, remove the plug from socket "9" of 25-pin connector (X). Connect the white wire "C-T9" of wiring harness (29) to socket "9" of the 25-pin connector on cab harness (W). See Illustration 14 and Illustration 15.
Remove the plug from socket "11" of 25-pin connector (X). Connect the yellow wire "C-T10"of wiring harness (29) to socket "11" of the 25-pin connector on cab harness (W). See Illustration 14 and Illustration 15.
Illustration 21 g01405582
The access panel