PLUG AS-CONNECTOR 2645732 - Caterpillar

System Operation Description:An "UNEXPECTED ENGINE SHUTDOWN" event will be activated for the following conditions:
The engine is running
Engine speed suddenly becomes zero
Auto Start/Stop function block has not initiated a shutdownThe EMCP 4 performs the following functions with an independent engine speed sensor that is dedicated to the EMCP 4 only:
Determines the engine speed, in rpm, from the Magnetic Pickup (Engine Speed Sensor) input pins
Detects diagnostics on the sensor
Annunciates an engine over/under speed conditionConditions Which Generate This Code:An "UNEXPECTED ENGINE SHUTDOWN" event will be activated for the following conditions:
The engine is running
Engine speed suddenly becomes zero
Auto Start/Stop function block has not initiated a shutdownTest Step 1. TALK TO THE OPERATOR
Determine the conditions that caused the unexpected shutdown. Expected Result:An unexpected shutdown was caused by an occurrence known that to the operator and the operator would like to put the genset back into service.Results:
OK - The operator is able to determine the cause for the "UNEXPECTED ENGINE SHUTDOWN". The condition has been repaired. The operator requests that the genset is put back into service.Repair: Reset the genset. Resume normal operation and verify that the problem has been corrected.STOP
NOT OK - The "UNEXPECTED ENGINE SHUTDOWN" was not caused by an occurrence known to the operator. Proceed to Test Step 2Test Step 2. CHECK FOR OTHER DIAGNOSTIC CODES.
Check for active diagnostic codes on the Engine ECM and the EMCP 4. If any codes are present, correct the diagnostic codes first. Expected Result:No other diagnostic codes or indicators are active.Results:
OK - No other diagnostic codes or indicators are active.Repair: Refer to the engine Troubleshooting manual for more information on engine unexpected engine shutdowns for your particular genset.STOP
NOT OK - Another diagnostic code is active or an indicator is active.Repair: Exit this procedure. Troubleshoot the active code or indicator. Resume normal operation and verify that the problem has been corrected.STOP