PLUG AS 3785571 - Caterpillar

Remove the bolts that hold the VIMS Guardian ECM to the plate assembly.
Illustration 24 g01545540
(18) E972-BU (19) 195-7970 Pin Remover (20) F419-YL (21) F418-GN
Remove the following three wires from the J connector on the VIMS ECM with a 195-7970 Pin Remover (19) :J2 Pin 66 - E972-BU (18) J2 Pin 41 - F419-YL (20) J2 Pin 40 - F418-GN (21)
Illustration 25 g01423197
Insert the three loose wires from the 299-4675 Wiring Harness into the J connector on the VIMS ECM.
Insert F418-GN into J2 pin 40.
Insert F419-YL into J2 pin 41.
Insert E972-BU into J2 pin 66.
Illustration 26 g01545553
(18) E972-BU (20) F419-YL (21) F418-GN
Insert the three wires that were removed from the VIMS ECM into the open 3-pin DT connector in the 299-4675 Wiring Harness .
Insert E972-BU (18) into pin A.
Insert F419-YL (20) into pin B.
Insert F418-GN (21) into pin C.
Illustration 27 g02229753
Illustration shows the isolators after installation
Use a 194-7583 Plate As in order to remove the 8R-6927 Bosses .
Drill holes in the plate in order to mount the VIMS Communicator in the center of the plate.
Mount the VIMS Communicator to the plate. Use bolts, nuts, and suitable rubber isolator/mounts.
Illustration 28 g01426742
(25) 255-2772 Spacer (26) 101-9759 Spacer (27) 8T-7352 Bolt
Install the following components as one assembly to the tractor: the Guardian ECM, the Guardian hardware, the VIMS Communicator and the plate.
Table 1
Item     Part Number     Description     Quantity    
(25)     255-2772     Spacer     2    
(26)     101-9759     Spacer     2    
(27)     8T-7352     Bolt     4    
    8T-4224     Hard Washer     4    
    Suitable isolation mounts (1)         4    
( 1 ) Isolators/Mounts should be purchased from outside supplierRefer to Table 1 for the parts that are called out in Illustration 28.
Illustration 29 g01426744
Connect the VIMS Communicator harness at plug (28) and plug (29) .
Connect the two loose wires from the 299-4675 Wiring Harness to a suitable power and ground.Red - 24 V switched powerBlack - Ground
Connect the VIMS Communicator to a radio system with an Ethernet cable.