PLUG-PLASTIC 3961170 - Caterpillar

Restoring Display Settings or Machine Settings
Use the "Restore Settings" dialog in order to restore previously saved display settings or machine settings. From this dialog, you can restore the full configuration settings of the Display. These settings may be stored in previously saved:
display settings files
machine settings filesBe sure to restore the correct machine settings file for your machine. Display settings files can be used for any machine, regardless of type.Note: The machine settings file contains the machine dimensions. Only use the machine settings file on the same machine that the file was created on.Note: When you restore display or machine settings, the configuration settings for the Receiver and the brightness settings of the Display are not changed.AccuGrade Systems are unable to restore the angle sensor calibration settings.The "Restore Settings" dialog lists the settings files on the data card.In order to access the "Restore Settings" dialog complete the following steps:
Be sure that there is a data card inserted in the Display.
Illustration 1 g01676757
From the "Setup Menu - Configuration" dialog, press the Down arrow or the Up arrow until "Restore Settings" is highlighted.
Illustration 2 g01672914
(1) LCD (2) Soft Key Labels (3) Soft Keys (4) Escape Key (5 ) Next Key (6) Power Key (7) "+" Key (8) Arrow Keys (9) "-" Key (10) "OK" Key (11) Menu Key (12) "Data Card Slot"
Illustration 3 g01270114
Press the "OK" key (10) .The "Restore Settings" dialog opens. Refer to Illustration 3.
Use the Arrow Keys (8) in order to select one of the following settings:
Display Settings
Machine Settings
Press the "OK" key (10) .The "Restore Settings" dialog appears that lists the setting files that are on the data card.
Press the Down arrow or the Up arrow in order to select one of the settings.
Press the "OK" key (10) in order to confirm the settings.Depending on what was selected in the "Restore Settings" dialog, one of the messages shown in Table 1 will appear:
Table 1
Possible Messages    
File Type     Message    
Display settings     Restoring Display Settings. Please wait...    
Machine settings     Restoring Machine Settings. Please wait...    Note: Caterpillar recommends that you check the Blade Wear setting when you restore a machine settings file. A dialog warns you to do this.In order to close the dialog without selecting a settings file, press the Escape key (4). The "Restore Settings" dialog appears.If you attempt to restore an invalid settings file, a warning message appears.
Press the "OK" key (10) .
Press the Escape key (4) in order to go back to the "Setup Menu - Configuration" dialog. Press the Escape key (4) again in order to exit the "Setup Menu - Configuration" dialog. The changes take effect immediately.Always check the "Blade Wear" dialog. The machine cutting edge may have worn (or been renewed) since the Machine Settings were saved.