PLUG AS-CONNECTOR 4610667 - Caterpillar

Illustration 1 g00484197
Remove gear assembly (1) .
Illustration 2 g00484198
Remove bronze thrust washer (2) .
Illustration 3 g00484199
Remove two dowel pins (3) . Remove bearing sleeve (4) .
Illustration 4 g00484242
Remove bronze thrust washer (5) from the flywheel housing. Remove two dowel pins (6) .
Illustration 5 g00484341
Remove seat (7) and bearing sleeve (8) from the flywheel housing.
Illustration 6 g00484342
Remove two bolts (11) , shaft (10) and the two O-rings. Remove idler gear (9) . Remove the bearing from idler gear (9) .Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Check the condition of the O-ring seals. If the O-ring seals are worn or damaged, use new parts for replacement.
Illustration 7 g00484342
Use Tool (A) and install the bearing in idler gear (9) . The bearing must not project beyond either face.
Install the two O-ring seals, shaft (10) , idler gear (9) and two bolts (11) . Apply 5P-3413 Pipe Sealant to the threads of the two bolts (11) prior to installation. Tighten two bolts (11) to a torque of 135 15 N m (100 11 lb ft) .
Illustration 8 g00484341
Use Tool (A) and install bearing sleeve (8) and seal (7) in the flywheel housing.
Illustration 9 g00484242
Install two dowel pins (6) . Install bronze thrust washer (5) in the flywheel housing.
Illustration 10 g00484199
Coat bearing sleeve (4) with clean engine oil. Use Tool (A) and install bearing sleeve (4) . Install two dowel pins (3) .
Illustration 11 g00484198
Install bronze thrust washer (2) .
Illustration 12 g00484197
Install gear assembly (1) .End By: Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".