PLUG AS-CONN 4647371 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-9200     Lever Puller Hoist     1    
B     138-7573     Link Bracket     2    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01334735
Illustration 2 g01334789
Connect Tooling (A) and Tooling (B) to hydraulic tank (9). The weight of hydraulic tank (9) is 99 kg (219 lb).
Install hydraulic tank (9). Install bracket (14) .
Install bolts (13). Tighten bolts (13) to a torque of 100 20 N m (74 15 lb ft).
Connect hose assembly (12) .
Illustration 3 g01334770
Install bolts (11). Tighten bolts (11) to a torque of 100 20 N m (74 15 lb ft).
Connect tube assembly (10) .
Illustration 4 g01334720
Install nuts (8). Tighten nuts (8) to a torque of 100 20 N m (74 15 lb ft).
Illustration 5 g01334698
Connect harness assembly (7). Connect hose assembly (6). Install hose assembly (5) .
Illustration 6 g01334691
Install cover (4) .
Illustration 7 g01334690
Connect hose assembly (3) .
Illustration 8 g01334661
Install bolts (2). Connect hose assembly (1) .End By:
Install the Cab. Refer to Disassembly and Assembly, "Cab - Remove and Install".
Install the left side track brake. Refer to Disassembly and Assembly, "Trake Brake - Remove".