PLUG AS 5367946 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Engine Oil and Filter - Change
Fuel System - Prime
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Generator - Dry
Generator Set - Test
Rotating Rectifier - Check
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Load - Check
Walk-Around Inspection
Every Week
Generator - Inspect
Every 50 Service Hours or Weekly
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Every 250 Service Hours
Engine Oil Sample - Obtain
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Engine Valve Lash - Check
Every 500 Service Hours or 1 Year
Belts - Inspect/Adjust/Replace
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 1000 Service Hours or 1 Year
Engine Valve Lash - Check
Rotating Rectifier - Check
Water Pump - Inspect
Every 2000 Service Hours or 1 Year
Alternator - Inspect
Engine Mounts - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Every Year
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Coolant Temperature Regulator - Replace
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change