PLUG-O-RING 5P4483 - Caterpillar

This maintenance procedure shall be performed when the major overhaul is performed. Refer to this Operation and Maintenance Manual, "Maintenance Recommendations" article for information about the maintenance interval for the major overhaul.Clean the Oil Cooler Core
Remove the core. Refer to the Disassembly and Assembly Manual, "Oil Cooler - Remove" for the procedure.
Turn the oil cooler core on one side to remove debris. Remove the debris that is accessible.
Do not use a high concentration of caustic cleaner to clean the core. A high concentration of caustic cleaner can attack the internal metals of the core and cause leakage. Only use the recommended concentration of cleaner.
Back flush the core with cleaner.Caterpillar recommends the use of Hydrosolv liquid cleaner. Table 1 lists Hydrosolv liquid cleaners that are available from your Caterpillar dealer.
Table 1
Hydrosolv Liquid Cleaners(1)
Part Number Description Size
1U-5490 Hydrosolv 4165 19 L (5 US gal)
174-6854 Hydrosolv 100 19 L (5 US gal)
(1) Use a two to five percent concentration of the cleaner at temperatures up to 93°C (200°F). Refer to Application Guide, NEHS0526 or consult your Caterpillar dealer for more information.
Steam clean the core to remove any residue. Flush the fins of the oil cooler core. Remove any other trapped debris from the inside and from the outside of the core.
Wash the core with hot, soapy water.
Flush the core thoroughly to remove residue and remaining debris. Flush the core with clean, fresh water until the water that is exiting the core is clear and free of debris.
Personal injury can result from air pressure.Personal injury can result without following proper procedure. When using pressure air, wear a protective face shield and protective clothing.The maximum air pressure for cleaning purposes must be reduced to 205 kPa (30 psi) when the air nozzle is deadheaded.
Dry the core with compressed air. Direct the air in the reverse direction of the normal flow.Test the Oil Cooler Core
Inspect the core for trapped debris and cleanliness. If necessary, remove the debris and repeat the cleaning procedure.
Inspect the core for damage and perform a pressure test to detect leaks. Many shops that service radiators are equipped to perform pressure tests.
Plug both ends of the oil cooler core and pressurize the core to 205 kPa (30 psi). Submerge the core in water. Look for bubbles which are being emitted from the core. The bubbles are evidence of leaks.
If any leaks are found, do not attempt to repair the core. Install a core that is clean and a core that passes the pressure test in step 3. Refer to the Disassembly and Assembly Manual, "Oil Cooler - Install" for the procedure.For more information on cleaning the core, consult your Caterpillar dealer.