PLUG, MAGNETIC PIPE 63020013 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the air tank. Refer to Operation and Maintenance Manual, "Air Tank Moisture and Sediment - Drain" for the correct procedure.
Turn the battery disconnect switch into the OFF position.
Illustration 1 g00938181
Disconnect negative battery cable (1) .
Illustration 2 g01074457
Disconnect hose (4) and disconnect harness assembly (3) .
Remove hand hold (2) .
Illustration 3 g01074475
Disconnect tube assemblies (5) .
Remove bolts (7). Remove air dryer (6) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 4 g01074475
Install air dryer (6). Install bolts (7) .
Connect tube assemblies (5) .
Illustration 5 g01074457
Install hand hold (2) .
Connect hose (4) and connect harness assembly (3) .
Illustration 6 g00938181
Connect negative battery cable (1) .
Turn the battery disconnect switch to the ON position.