PLUG 6P5335 - Caterpillar

Illustration 11 g02130427
Move propel mode switch (10) to the PAVE position.
Move propel lever (3) to the NEUTRAL position.
Press OK key (9) .Note: If the display does not advance after pressing the OK key, observe the display. Also, make sure that all the required conditions are met.
Illustration 12 g02131213
Note: An operator message will be displayed that will inform the operator that the machine will move at a high rate of speed and the message will inform the operator to allow adequate space during this step.
Move parking brake switch (1) to the OFF position.Note: The parking brake switch on both instrument panels must be in the OFF position in order for the machine to move.
Illustration 13 g02130431
Squeeze trigger (11), and move propel lever (3) to the FULL REVERSE position.
Press OK key (9) .Note: If the display does not advance after pressing the OK key, observe the display. Also, make sure that all the required conditions are met.
Illustration 14 g02131255
Display should read "Calibrating speed sensors".Note: Observe the display. When the speed sensors have been calibrated, the display will prompt the operator to move the propel lever to the NEUTRAL position.
Illustration 15 g02131256
Move propel lever (3) to the NEUTRAL position.
Illustration 16 g02131257
Note: The machine will move at a high rate of speed. Allow adequate space during this step.
Squeeze trigger (11), and move propel lever (3) to the FULL REVERSE position.
Illustration 17 g02131260
Display should read "Calibrating initial current for reverse pumps".Note: At this point, the system is performing the coarse calibration of the initial current for the propel pumps.
Illustration 18 g02131262
Move propel lever (3) to the NEUTRAL position.
Illustration 19 g02131263
Note: The machine will move at a high rate of speed. Allow adequate space during this step.
Squeeze trigger (11), and move propel lever (3) to the FULL REVERSE position.
Illustration 20 g02131267
Display should read "Calibrating initial current for reverse pumps".Note: At this point, the system is performing the fine calibration of the initial current for the propel pumps.
Illustration 21 g02131279
Move propel lever (3) to the NEUTRAL position.
Illustration 22 g02131280
The display should now read "CALIBRATION COMPLETE". Push back key (12) to return to calibration screen.
Push home key (7) in order to exit the calibration screen.
Move parking brake switch (1) to the ON position.
Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Illustration 23 g02130471
After the engine reaches low idle, move engine start switch (13) to the OFF position.