PLUG 9R5616 - Caterpillar

Illustration 1 g01152977
(8) Up key
(9) Right key
(10) Home key
(11) Main menu key
(12) Left key
(13) Down key
(14) Cancel key or back key
(15) OK key The "ENTER PASSWORD" menu option is entered by selecting "SERVICE" from the "MAIN MENU". Once "SERVICE" is selected, press the "OK" key (15).The following screen will now be displayed.
Illustration 2 g01149075The keys for direction are used to input the password. Press the left key (12) or the right key (9) in order to highlight the desired character. Then press the "OK" key (15) in order to set the desired character. Press the back key (14) in order to delete a selected character. When 4 characters have been entered the monitoring system will check the password. If the password is correct the user will be allowed access to the menu.If the password is incorrect, "INVALID PASSWORD" will be displayed. Press the "OK" key (15) in order to retry the password in the previous screen. Refer to Illustration 2.Note: The initial user password is "0001", and the service password is "FFF2".The password that allows access to all menus that are used for service is "FFF2". Press left key (12) or right key (9) in order to change the position of the flashing character. When the desired character is highlighted press the "OK" key (15). After the "OK" key (15) is pressed, the monitor will prompt the user for the next character. After all four characters are entered the monitor will display Illustration 3.
Illustration 3 g01150618When the correct password has been entered, Illustration 4 is displayed. This indicates that service mode has been entered.
Illustration 4 g01154411Note: Once the password has been entered, the "SERVICE" menu options will be active until the machine is powered down (Key OFF). Upon the next start (Key ON), the password must be re-entered to enable the "SERVICE" menu options again.