AVSPARE.COM
parts catalog

PLUNGER A 0876712 - Caterpillar



0876712 PLUNGER A Caterpillar parts PLUNGER
Rating:
56
Alternative (cross code) number:
CA0876712
087-6712
0876712
Caterpillar 0876712 PLUNGER A

Buy PLUNGER A 0876712 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-1859 Retaining Ring Pliers 1
B - Loctite Gasket Maker #2 - Start By:
Remove the screed.
Illustration 1 g06258399
Drain the hydraulic oil from final drive planetary (auger conveyor) (2). Refer to Operation and Maintenance Manual, "Conveyor Planetary Drive (Auger) Oil - Check" for the correct procedure.
Remove two bolts (3) and the two washers.
Position piston motor (auger conveyor) (1) out of the way.
Illustration 2 g06258403
Remove eight bolts (7) and cover (8).
Loosen four bolts (6).
Loosen nut (5). Turn bolt (4) to lower final drive planetary (auger conveyor) (2).
Illustration 3 g06258405
Remove the cotter pins, the side plate, and the master link.
Remove chain (auger conveyor) (9).
Illustration 4 g06258414
Attach a suitable lifting device to final drive planetary (auger conveyor) (2) and plate assembly (10). The weight of final drive planetary (auger conveyor) (2). and plate assembly (10) is approximately 67 kg (148 lb).
Remove four bolts (6), plate assembly (10), and final drive planetary (auger conveyor) (2).
Illustration 5 g06258420
Use Tooling (A) to remove retaining ring (11). Remove retaining ring (11) and washer (12).
Loosen set screws (13).
Remove sprocket (14) and shaft key (15).
Illustration 6 g06258424
Typical example
Remove ten bolts (16), the washers, and final drive planetary (auger conveyor) (2) from plate assembly (10).Installation Procedure
Install final drive planetary (auger conveyor) (2) in the reverse order of removal.
Set the tension for chain (auger conveyor) (9).
Attach a pull gauge to the midpoint of chain (auger conveyor) (9).
Apply a pulling force of 67 N (15 lb).
The deflection of chain (auger conveyor) (9) should be 5 1 mm (0.20 0.04 inch).
Apply Tooling (B) to cover (8).


Parts plunger Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.