PLUNGER ASSEM. 7K1045 - Caterpillar

Data Broadcasts
Data concerning this machine, the condition of the machine, and the operation of the machine is being transmitted by Cat Product Link to Caterpillar and/or Cat dealers. The data is used to serve the customer better and to improve upon Cat products and services. The information transmitted may include: machine serial number, machine location, and operational data, including but not limited to: fault codes, emissions data, fuel usage, service meter hours, software, and hardware version numbers and installed attachments.Caterpillar and/or Cat dealers may use this information for various purposes. Refer to the following list for possible uses:
Providing services to the customer and/or the machine
Checking or maintaining Cat Product Link equipment
Monitoring the health of the machine or performance
Helping maintain the machine and/or improve the efficiency of the machine
Evaluating or improving Cat products and services
Complying with legal requirements and valid court orders
Performing market research
Offering the customer new products and servicesCaterpillar may share some or all the collected information with Caterpillar affiliated companies, dealers, and authorized representatives. Caterpillar will not sell or rent collected information to any other third party and will exercise reasonable efforts to keep the information secure. Caterpillar recognizes and respects customer privacy. For more information, please contact your local Cat dealer.Operation in a Blast Site for Product Link Radios
This equipment is equipped with a Cat® Product Link communication device. When electric detonators are being used for blasting operations, radio frequency devices can cause interference with electric detonators for blasting operations which can result in serious injury or death. The Product Link communication device should be deactivated within the distance mandated under all applicable national or local regulatory requirements. In the absence of any regulatory requirements Caterpillar recommends the end user perform their own risk assessment to determine safe operating distance.
Refer to your products Operation and Maintenance Manual Supplement, "Regulatory Compliance Information" for more information.For information regarding the methods to disable the Cat Product Link communication device, please refer to your specific Cat Product Link manual listed below:
Operation and Maintenance Manual, SEBU8142, "Product Link - 121SR/321SR/420/421/522/523"
Operation and Maintenance Manual, SEBU8832, "Product Link PLE601, PL641, PL631, PL542, PL240, PL241, PL141, PL131, PL161, and G0100 Systems"Note: If no radio disable switch is installed and the equipment will be operating near a blast zone, a Product Link radio disable switch may be installed on the equipment. The switch will allow the Cat Product Link communication device to be shut off by the operator from the equipment control panel. For more details and installation procedures, refer to the following:
Special Instruction, "Installation Procedure forProduct Link PLE640 Systems"REHS7339
Special Instruction, "Installation Procedure for the Elite Product Link PLE601, PLE641, and PLE631 Systems", REHS8850
Special Instruction, "Installation Procedure for the Product Link PL131, PL141, and PL161 Systems", SEHS0377
Special Instruction, "Installation Procedure for the Pro Product Link PL641 and PL631 Systems", REHS9111