PLUNGER 8S1016 - Caterpillar

Illustration 1 g06218275
Table 1
Item Qty Part Specification Description
A - - New liner bore is 145.000 0.025 mm (5.7086 0.0010 inch).
B - - Thickness of flange on liner is 8.890 0.020 mm (0.3500 0.0008 inch).
The minimum thickness of the part that can be used again is 8.870 mm (0.3492 inch).
Use the following procedure for installing the cylinder liner into the cylinder block:
1. Apply 5P-3975 Rubber Lubricant on the surfaces of the cylinder liner bore. Apply 5P-3975 Rubber Lubricant on the rubber seals on the lower part of the cylinder liner.
2. Put filler band (1) completely in clean engine oil for a moment.
3. Install the filler band in the groove under the liner flange without delay.
4. Install the liner in the bore immediately, before the filler band expands.