POINT 5P7262 - Caterpillar

6. Place a wood block on the circle draw bar. Lower scarifier lift cylinder (5) to the block.7. Remove two bolts (7) and washers from pin lock (8). Remove lock (8) from the mounting. Remove pin (9) that holds the rod end of scarifier lift cylinder (5) to the mounting bracket. Remove scarifier lift cylinder (5) from the machine. The weight of scarifier lift cylinder (5) is 31.3 Kg (69 lb). 8. Remove two bolts (10) and washers from cap (11). Remove cap (11) and shims from sleeve assembly (12). 9. Loosen bolt (14) on sleeve assembly (12). Remove pin (13) from sleeve assembly (12) and link assembly (15). Remove sleeve assembly (12) from link assembly (15). Pivot link assembly (15) and lower it to the ground. 10. Remove two bolts (16) and washers from cap (17). Remove cap (17) and the shims from link assembly (15). Remove link assembly (15) from its mounting.11. Repeat Steps 8 through 10 for the removal of sleeve assembly (12) and link assembly (15) on the other side of the machine. 12. Loosen two nuts (18) on arm assembly (19). Remove arm assembly (19) and key (20) from shaft (21). The weight of arm assembly (19) is 20 Kg (45 lb).13. Repeat Step 12 for the arm assembly on the other side of the machine. 14. Attach lifting slings and a hoist to shaft (21) and apply a slight lifting pressure. Remove four nuts (22), bolts and washers from two brackets (23). Remove shaft (21).and two brackets (23), as a unit, from the mounting bracket. The combined weight of the shaft and brackets is 100 Kg (220 lb). 15. Note the position of bracket (23) for installation purposes. Remove two brackets (23) from shaft (21). The weight of each bracket is 25 Kg (55 lb). 16. Use a press and Tooling (A) in order to remove two bearing sleeves from each of two brackets (23). 17. Attach lifting slings and a hoist to right side draw bar assembly (25). Place an appropriate floor jack under block assembly (27) in order to prevent block assembly (27) from falling during removal of draw bar assemblies (25).18. Remove two bolts (26), washers and nuts that hold right side draw bar assembly (25) to block assembly (27).19. Remove bolt (28), washer and nut from collar (29). Remove collar (29) from shaft (30).20. Remove draw bar assembly (25). The weight of draw bar assembly (25) is 140 Kg (305 lb).21. Attach lifting slings and a hoist to left side draw bar assembly (24). Repeat Steps 18 through 20 for removal of left side draw bar assembly (24). 22. Remove shaft 930) from bolster assembly (32). Remove four bolts (31) and washers that secure bolster assembly (32) to its mounting plate. Remove bolster assembly (32) from the mounting plate. 23. Remove shank (33) by lifting lock pin (34) and pulling shank (33) out of the bottom of block assembly (27). Repeat this step to remove all of the