POSITIONER G. 2K7135 - Caterpillar

Installing the Films
Illustration 22 g03878629
View of film installation
(T) 20 3 mm (0.8 0.1 inch)
(U) 85 3 mm (3.3 0.1 inch)
(7) 239-4990 Film
(8) 239-4991 Film
For ANSI machines, locate and install film (7) onto the left side plate of the frame assembly.Note: For ISO machines, locate and install film (8).Installing the Rocker Switch and the Relay
Illustration 23 g03878644
View of console assembly
(V) Right-hand console assembly
(W) Existing plug
Lower the cab safely. Locate right-hand console assembly (V) inside the cab of the machine.
Remove plug (W) on the fifth position from front to rear on switch cover assembly. from right-hand console assembly (V).
Pull the connector from the panel harness assembly and plug rocker switch assembly (9) onto the connector.
Insert rocker switch assembly (9) connection through the newly open slot on right-hand console assembly (V) until the tabs on the switch engage into place.
Table 3
265-9526 Rocker Switch As.and Connector L-C23 Connection
Position Wire Number Color - Gage
1 F738-L72 WH-18-GXL
2 200-L142 BK-18-GXL
3 F739-L73 GR-18-GXL
4 Not used Not used
5 Not used Not used
6 Not used Not used
7 200L-109 BK-18-GXL
8 614-L136 PU-18-GXL
Illustration 24 g03878651
View of cover assembly
(S) Existing cover assembly
Locate cover assembly (X) from the relay and fuse panel on the rear cab liner near the right-hand side of the machine. Remove cover assembly (X) and retain.
Illustration 25 g03878673
View of relay installation
(X) Existing cover assembly
(3) 146-9439 Relay As
Install relay assembly (3) onto the fourth position R4 of the lower fuse and relay panel. Reinstall cover assembly (X).Configuring the Ride Control Feature
Note: Ensure that the machine ECM has the latest software available installed. The Ride Control feature requires latest software mentioned under 361-6395 Machine Electronic Control Module.
To enable the Ride Control feature in the Cat Electronic Technician (ET) service tool, connect the appropriate communication device onto the communication port inside the fuse panel.Note: ET service tool 2015A (or higher) is recommended.
With the engine stopped, switch the engine start switch to ON. Then, open the ET service tool.
Illustration 26 g03878680
Select "Service" from the toolbar. Then, select "Machine Configuration" from the drop-down menu.
Illustration 27 g03878681
Change the "Ride Control System Installation "Status" from "Not Installed" to "Installed".
Illustration 28 g03878690
The Cat ET service tool will bring up a password screen and display the required information to retrieve a password.
Click the https://fps.cat.com link on the Cat ET screen to access the Cat Factory Password System (FPS). Enter the required information on the corresponding fields to obtain and record the password.
The Ride Control feature should now be enabled. Turn the engine start switch to OFF for at least 30 seconds. Then, turn the engine start switch back ON. The Ride Control feature should be activated in the next power cycle.
Illustration 29 g03878696
Return to the "Machine Configuration" option of the Cat ET screen and ensure that the "Ride Control System Installation Status" is set to "Installed".