POTENTIOMETER AS 2761827 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part number     Part Description     Qty    
A     9U-6124     Universal Metric Socket Set     1    
B     9U-6128     Universal Metric Socket (1)     1    
( 1 ) Part of the Universal Metric Socket Set
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: If the nut for the fuel injection pump drive gear is removed, you must tighten the nut for the fuel injection pump drive gear to 88 5 N m (65 4 lb ft).
Illustration 1 g00813430
Use a lifting sling and a hoist in order to secure the fuel injection pump (8). The weight of the fuel injection pump is 13 kg (29 lb).
Install a new gasket and install fuel injection pump (8) .
Ensure that the engine is in the top center position on No. 1 piston. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
Ensure that the mark on the front plate (3) and the mark on the fuel injection pump flange (4) are aligned.Refer to Testing and Adjusting, "Fuel Injection Timing-Check" for more information on fuel injection pump timing.Note: Use Tool (B) to install the bolts and washers that secure the fuel injection pump to the cylinder block.
Install the washers and bolts (9) that secure the fuel injection pump to the engine cylinder block.
Remove the sling from the fuel injection pump.
Connect oil line (6) to nipple (7) (not shown).
Tighten fitting (5) for oil line (6) .