POWER TRAIN AR 2394821 - Caterpillar

Table 2
Contact Description J2(1)
No.(2) Function Type
1 Key Switch Start STB
2 Implement Shutoff Sw - Pin 2 2A On/Off
3 Pitch Regenerate Solenoid 2A On/Off
4 AutoCarry Sol, Implement Shutoff Sol, Pitch Regen. Sol RETURN Load Return
5 Single Tilt Solenoid - Dual Tilt Valve S2 2A On/Off
6 Pitch Solenoid - Dual Tilt Valve S1 2A On/Off
7 AutoCarry Diverter Solenoid 2A On/Off
8 Dual Tilt/PCO (RV) Solenoid Return Load Return
22 Hydraulic Temperature Sensor Return Digital Return
23 Pilot Supply Filter Bypass Switch SWG
24 "Blade Control Raise/Lower Position Sensor 1" STG/PWM
25 "Blade Control Tilt Position Sensor " STG/PWM
26 "Blade Control Pitch Position Sensor" STG/PWM
27 Ripper Control Raise/Lower Position Sensor STG/PWM
28 Harness Code 0 SWG
29 Harness Code 1 SWG
30 Harness Code 1 SWG
31 Harness Code 3 SWG
32 Ripper Control In/Out Position Sensor STG/PWM
34 TCO Speed Signal STG/PWM
36 AutoBlade Assist Switch - Pin 1 SWG
37 AutoBlade Assist Switch - Pin 3 SWG
38 Auto Carry Switch - Pin 1 SWG
39 Auto Carry Switch - Pin 3 SWG
40 Winch Contorl Speool In/Out Position Sensor STG/PWM
41 Winch Control Drum Clutch Release Position Sensor STG/PWM
43 Ground Speed Radar STG/PWM
44 Winch Low Speed Lock (N.C.) SWG
45 Winch Control Low Speed Lock Switch (N.O.) SWG
46 Implement Shutoff Switch - Pin 4 SWG
47 Implement Shutoff Switch - Pin 6 SWG
48 Right Lift Cylinder Position Sensor STG/PWM
49 Left Lift Cylinder Position Sensor STG/PWM
58 Winch Shutoff Switch - Pin 1 SWG
59 Winch Shutoff Switch - Pin 3 SWG
64 Cut to Contour CAN Data Link + CAN B+
65 Cut to Contour CAN Data Link - CAN B-
67 Common CAN Data Link + CAN A+
68 Common CAN Data Link - CAN A-
(1) The ECM responds to an active input only when all the necessary conditions are satisfied.
(2) The connector contacts that are not listed are not used.