POWER TRAIN AR 3664868 - Caterpillar

Introduction
The tools that are listed below are used in order to install the 155-0423 Crankshaft Seal and Wear Sleeve on the crankshaft of the rear engine.Do not perform any procedure in this Special Instruction until you read this information and you understand this information.Installation
Table 1
Tools Needed     Quantity    
192-6339 Wear Sleeve Locator     1    
187-1841 Wear Sleeve Installer     1    
5P-8249 Hard Washer     4    
2J-3505 Full Nut     4    
9S-8858 Nut     1    
Illustration 1 g00814115
(1) Wear Sleeve Locator (2) Wear Sleeve Installer (3) Hard Washer (4) Full Nut (5) Nut
Bolt the locator (1) to the crankshaft. In order to assemble the locator to the crankshaft, use four of the flywheel bolts.
Place the 155-0423 Crankshaft Seal and Wear Sleeve in the installer (2) and place the installer over the five studs that are on the locator.Note: Do not separate the crankshaft seal and the wear sleeve.
Install the four washers (3) and nuts (4) on the outer studs.
Install the nut (5) on the center stud.
Tighten all five nuts equally in order to ensure proper installation.