POWERSHIFT TRANSMISSION ARRANGEMENT 2P3670 - Caterpillar

Illustration 1 g00285586
The operator's seat that is provided with this machine is in compliance with the appropriate class of "ISO 7096".Note: Adjust the seat for a new operator or at the beginning of each shift.The operator should be seated against the seat backrest. Adjust the seat so that the operator is allowed full travel of the pedals.Back Angle Adjustment - Lift handle (1) and allow the seat back to tilt forward. Push the front of the backrest in order to tilt the seat backward. Release handle (1) at the desired position. Adjustment of the Seat Height - There must not be anyone in the seat while the height is adjusted. Lift the seat height level lever (3) to the stop position. Hold lever (3) in the upward position in order to raise the seat upward or push the seat downward. Release the lever at one of the three positions.Fore/Aft Adjustment - Lift up on fore/aft handle (5). Move the seat forward or move the seat rearward until the desired position is attained. Release the handle in order to lock the seat into position.Angle Adjustment for the Bottom Cushion - Lift upward on seat cushion tilt handle (2). The seat will raise upward. If you push the front of the seat cushion downward, the seat will lower. Release the handle at one of the three positions.Weight Adjustment - Position the seat in the desired position. Extend the lever that is used for cranking from knob (4). Rotate the crank to the minus position for less support. Rotate the crank to the plus position for more support. Refer to the instruction plate and the indicator for the approximate weight setting. The instruction plate and the indicator are positioned next to the knob. Release the crank at the desired setting.Retractable Seat Belt - When the seat has been adjusted to fit the operator, secure the retractable seat belt.