PRECLEANER GP 7E7583 - Caterpillar

Install slider track (38) on upper housing (6). Install bolt (40), two bolts (39), the washers, locknut (37) and the washer. Tighten bolts (39) and (40) to a torque of 30 7 N m (22 5 lb ft).
Illustration 11 g00275842
Position air compressor (36) in the scissor assembly. Install clamp (35) and tie-wrap (34) in order to secure air compressor (36) to the scissor assembly. Tighten clamp (35) to a torque of 3.2 0.6 N m (29 5 lb in).
Position wiring harness (30). Install tie-wraps (31) in order to secure wiring harness (30) to the scissor assembly.
Connect tube (32) to fitting (33). Make sure that the tube is securely seated in the fitting.
Illustration 12 g00275841
Connect tube assembly (27) and two electrical connectors (29) to combination valve (28). Make sure that electrical connectors (29) are installed in the original positions.
Illustration 13 g00275840
Connect tube (22) to fitting (23). Make sure that the tube is securely seated in the fitting. Apply 9S-3263 Thread Lock on bolt (25). Position air spring (26) on the scissor assembly. Install bolt (25) in order to secure air spring (26). Tighten bolt (25) to a torque of 4.3 1 N m (38 9 lb in). Install two bumpers (24) .
Illustration 14 g00275839
Apply 5N-5561 Lubrication Compound to the scissor assembly at the point of installation for two rollers (21). Install two bearings (20), two rollers (21), and two tether belts (11) on scissor assembly (7) .
Illustration 15 g00275836
Install bearings (15) and (18), damper (16), pin (19) and nut (17) into lower housing (13). Tighten nut (17) to a torque of 40 8 N m (30 6 lb ft).
Illustration 16 g00275794
Illustration 17 g00275795
Install scissor assembly (7) into lower housing (13) .
Apply 9S-3263 Thread Lock to screw (14). Position the air spring on lower housing (13). Install screw (14). Tighten screw (14) to a torque of 4.3 1 N m (38 9 lb in).
Install the lower shaft assembly. Install locknut (12) and the lock washer. Tighten locknut (12) to a torque of 40 8 N m (30 6 lb ft).
Illustration 18 g00275793
Install bushing (10) into the lower housing. Install two tether belts (11) and two bearings (8). Apply 5N-5561 Lubrication Compound to the scissor assembly at the point of installation for rollers (9). Install rollers (9) on the scissor assembly.
Illustration 19 g00275792
Install upper housing (6) on scissor assembly (7) .
Illustration 20 g00275791
Install the upper shaft assembly. Install locknut (4) and the washer. Tighten the locknut to a torque of 40 8 N m (30 6 lb ft).
Install the lock washer and nut (5). Tighten the nut to a torque of 13.6 2.7 N m (10 2 lb ft). Apply 9S-3263 Thread Lock on the setscrew of knob (2). Install knob (2) and the setscrew.
Illustration 21 g00291083
Install boot (3) .
Install the seat on the air suspension.End By: Install the seat in the machine. Refer to Disassembly and Assembly, "Seat - Install".