PROBE-MAGNETIC 3841567 - Caterpillar

mode is used in order to monitor the generator set. Normal mode is also used to control the generator set. The GSC+ controls the engine according to the information which is received from the operator and the information that is received from the engine sensors. The GSC+ performs the following functions in normal mode:
Engine starting function
Monitors the important GSC+ conditions
Shows the important GSC+ conditions to the operator
Fault detection
Engine stoppingThe operator can identify normal mode by observing the display area. When the GSC+ is in normal mode, all shutdown indicators are OFF. The fault alarm indicator is OFF and "SERV" is NOT SHOWING on the upper display. When the GSC+ is in normal mode, the engine is able to start or the engine is able to run.Note: The optional Customer Communication Module (CCM) can remotely control certain generator set functions. This remote control can only occur when the engine control switch (ECS) is in the AUTO position. See Systems Operation, "System Communication Module (Customer)"for more information.Engine Starting Sequence
The GSC+ receives an engine start signal. The signal will be one of three.
The operator turns the ECS to the Manual Start position.
The ECS is in the AUTO position and the remote initiate contacts (IC) close.
The ECS is in the AUTO position and a start command is sent by the optional Customer Communication Module (CCM).
The GSC+ checks the system before beginning the cranking sequence. The GSC+ checks that no system faults are present. The GSC+ checks that all previous shutdown faults have been reset. Note that shutdown faults are removed by turning the ECS to OFF/RESETposition. The GSC+ also checks that the engine is not already running. If the engine is equipped with prelube, the GSC+ checks the status of the prelube. If the prelube is not complete, the GSC+ will not crank the engine.
The GSC+ starts the crank sequence.
On