PROTECTION GP-VANDALISM 1468414 - Caterpillar

Functional Test
The Caterpillar Monitoring System performs an automatic internal test when the machine is activated. Turning the engine start switch from the OFF position to the ON position will activate the test.The test verifies proper operation of the outputs (displays, indicator lamps, and audible alarms).The internal circuits are automatically checked.The operator must observe the outputs in order to determine whether the displays are operating properly. The length of time for the test is approximately 3 seconds.During this test, the alert indicators flash, the gauges will sweep, the Cat logo will display, and the operator profile selection will display. Also, the display window shows the following information:
All units of measurement (degrees, pressure, distance, rotational speed, and volume)
"X10" indicator
Symbol for hour meter
"8.8.8.X.8.8." on the digital readoutThe tachometer and the gauge needles ramp straight up. Then, the gauge needles go to the right and to the left. The gauge needles then go to the final position.
The gear/direction readout shows an asterisk.
The digital speedometer shows "188" mph and km/h.
The indicator lamp is on continuously.
The audible alarm sounds once.The display then goes into the Normal Mode of operation.Message Display
Illustration 2 g03691290
Control Buttons
(23) Four Way Navigation Key
(24) OK/Select
(25) Back/Previous
(26) Operator Select
(27) Information
(28) Backlight
(29) Digital Display Area Four Way Navigation Key (23) - This button is used for the following purposes: navigation, data information and a decrease in a setting value or an increase in a setting value.OK/Select Button (24) - This button selects the currently highlighted menu option. The "OK" button also acknowledges any Level 1, Level 2, or Level 3 diagnostic message on the display screen.Back/Previous Button (25) - This button is used in order to return to the previous screen.Operator Select Button (26) - This button is used in order to return to the operator menu.Information Button (27) - This button is used in order to display the main menu. Press the Information Button twice in order to return to the performance menu.Backlight Button (28) - This button is used in order to adjust the light on the display area. Press the button and hold the button in order to adjust the backlight intensity with the left arrow key and the right arrow key. Press the back light button again while in backlight adjust mode in order to adjust the contrast.Digital Display Area (29) - This Message system shows information on digital display area (29).Default Menu
Illustration 3 g03467039The default menu will display the engine rpm, the gear, and the machine speed.Performance Menu
From the default menu, press down on the Four Way Navigation key to display the "PERFORMANCE" pages.The following