PROTECTION GP-VANDALISM 1W5726 - Caterpillar

Illustration 1 g01650213
Illustration 2 g01156917
View A-A
When the electric starting motor is viewed from the drive end, the motor rotates in the following direction. ... ClockwiseNo load conditions at 25 °C (77 °F) Speed ... 7200 1250 rpmCurrent ... 82.5 17.5 AmpVoltage ... 23 VNote: A maximum of three cable terminals or wire terminals may be used with the battery terminal nut. A maximum of two of the terminals may be equal to or greater than 0 AWG. (B) Clearance between the pinion and the housing assembly ... 4.6 mm (0.18 inch) (1) Final installation torque for the battery terminal nut ... 30.5 3.5 N m (22 3 lb ft) (2) Final installation torque for the ground terminal nut ... 30.5 3.5 N m (22 3 lb ft) (3) Final installation torque for the ground terminal nut ... 2.25 0.25 N m (20 2 lb in)Note: The switch terminal must be insulated with heat shrink tubing. Do not use molded terminals. (4) Final installation torque for the switch terminal nut ... 2.25 0.25 N m (20 2 lb in)Note: The internal Torx screw must be held during tightening or loosening of the motor terminal nut (5). (5) Final installation torque for the motor terminal nut ... 14.7 3.4 N m (11 3 lb ft) (6) Final installation torque for the motor frame terminal nut ... 8 3 N m (70 27 lb in)Solenoid assemblyCurrent draw at 20 V and 25 °C (77 °F) Pull-in windings ... 57 AmpHold-in windings ... 13 AmpMaximum rated current ... 750 Amp