PROTECTION GP-VANDALISM 5N8553 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the condition of the gaskets and the O-ring seals. If the gaskets or the O-ring seals are worn or damaged, use new parts for replacement.Note: For more information on the water pump, refer to Specifications, "Water Pump".
Illustration 1 g00578978
Place the seal and water pump (11) in position on the engine. Install nuts (8) and bolt (9).
Install the gasket and bolts (10).
Illustration 2 g00578980
Place elbow (5) in position with the gaskets, the seal, and flange (6). Lightly lubricate the bore and the seal with glycerin. Install bolts (4).
Install bolts (7).
Illustration 3 g00578974
Place the O-ring seals and tube (3) in position on the engine. Lightly lubricate the bore and the seal with glycerin.
Place the gasket and elbow (1) in position. Install bolts (2).
Fill the cooling system with coolant to the correct level. Refer to Operation and Maintenance Manual, "Refill Capacities".