PROTECTION COVER GROUP 9G9288 - Caterpillar

Illustration 34 g03560922
The Cat ET dialog shown in Illustration 34 will appear. The dialog will have the message "No data is available. Load from the ECM now?". Click "Yes" .
Illustration 35 g03560923
Select "Alarm Module #1" from the ECM list. The alarm module will allow the software to connect to the Annunciator.
Illustration 36 g03560924
The system will load the annunciator configuration.
Illustration 37 g03560928
After the data is loaded, the current file parameters will be displayed.
Select which control configuration data that is to be programmed into the EMCP 4.3 by clicking the box that is to the left of the parameter. A check mark must appear next to the parameter that is to be added. If a parameter is not desired, do not click that parameter. If the box has a check mark, but that parameter is not desired, click the box again to remove the check mark for that parameter. Refer to Illustration 30 as an example of having the boxes checked next to the desired parameters.
Illustration 38 g03560998
After the desired changes are completed, click "Save to File" to save .xml the file. Make sure to note where the file is stored.Programming New Configurations on the Annunciator Control
Connect to the EMCP 4.3, using the Cat Service Tool, to the CAN 2 port. From the "Service Tool" menu, select the following.
Select the "Service" tab.
Select "Copy Configuration"
Select "ECM Replacement".Refer Illustration 33.
Illustration 39 g03561017
After the desired changes are completed, click "Load from File" to save the file.
Illustration 40 g03561019
Navigate to the desired file and click "Open". Refer to the "General Kit Information" for the most recent configuration file (.xml). The software will confirm that the file has been opened. Refer to Illustration 40.
Select which control configuration data that is to be programmed into the EMCP 4.3 by clicking the box that is to the left of the parameter. A check mark must appear next to the parameter that is to be added. If a parameter is not desired, do not click that parameter. If the box is checked, but that parameter is not desired, click the box again to remove the check mark for that parameter. Refer to Illustration 30 as an example of having the boxes checked next to the desired parameters.
Illustration 41 g03561020
After the desired changes are completed, click "Program ECM" to load the file into the EMCP 4.3.
Illustration 42 g03561022
The dialog in Illustration 42 will appear.
Click "Yes".
Illustration 43 g03561023
Next, select "Alarm Module #1" from the list of controls.
Illustration 44 g03561026
Allow the software to configure the set parameters to the annunciator.
The software will confirm the programming of the control.
Illustration 45 g03561028